Revue des Sciences Fondamentales Appliquées
Volume 8, Numéro 2, Pages 327-345
2016-05-01

Experimental Validation Of A Dual Loop Control Of Two Phases Interleaved Boost Converter For Fuel Cell Applications



Authors : Kraa O. . Ghodbane H. . Saadi R. . Ayad M.y. . Becherif M. . Bahri M. . Aboubou A. .

Abstract

In this paper, a modelling, an implementation and a control of a dc-dc converter structure called “two phases Interleaved Boost Converter (IBC)” will be presented. This topology is widely used in order to reduce the input current ripples and the size of passive component with high efficiency. The control of the IBC converter is designed by dual loop control that contains a voltage loop with a linear PI controller and a fast current loop with a non-linear sliding controller to ensure a good tracking in steady state and fast performance in transient state. The proposed control loop has been validated, first by the simulation results under Matlab-Simulink and after by the experimental results using a small-scale test bench with the dSPACE-1104 card.

Keywords

Interleaved Boost Converter; fuel cell; PI; sliding mode control.

Les articles similaires

Design And Simulation Of A Valveless Piezoelectric Micropump For Fuel Delivery In Fuel Cell Devices

Rihan Yasser . 
pages 23-26.

Design And Simulation Of Shortcut Current Mpptracking Technique To Control Boost Converter

Serghine H. .  Chenni R. .  Nebti K. . 
pages 37-44.

Modeling And Validation Of Fuel Cell Pemfc

Benchouia N. .  Hadjadj A.e. .  Derghal A. .  Khochemane L. .  Mahmah B. . 
pages 365-377.

Thin Film Si Solar Cell And Solid Oxide Fuel Cell Technologies For A Low Cost, Environmentally Friendly And Sustainable Source Of Energy

Boudghene Stambouli A. .  Djerroud S. . 
pages 267-284.

A Modified Perturb And Observe Maximum Power Point Tracking Algorithm For A Standalone Single Phase Photovoltaic System Using Boost Converter

Taïssala A. .  Djongyang N. .  Tom A. .  Nicodem N. . 
pages 575-591.

Formats de citation