Revue Nature et Technologie
Volume 3, Numéro 1, Pages 24-33
2011-01-30
Authors : Badoud Abd Essalam . Khemliche Mabrouk .
In this paper Bond Graph modeling, simulation and monitoring of ultrasonic linear motors are presented. Only the vibration of piezoelectric ceramics and stator will be taken into account. Contact problems between stator and rotor (slider) are not treated here. So, standing and travelling waves will be briefly presented since the majority of the motors use another wave type to generate the stator vibration and thus obtain the elliptic trajectory of the points on the surface of the stator in the first time. Then, electric equivalent circuit will be presented with the aim for giving a general idea of another way of graphical modeling of the vibrator introduced and developed. The simulations of an ultrasonic linear motor are then performed and experimental results on a prototype built at the laboratory are presented. Finally, validation of the Bond Graph method for modeling is carried out, comparing both simulation and experiment results. This paper describes the application of the FDI approach to an electrical system. We demonstrate the FDI effectiveness with real data collected from our automotive test. We introduce the analysis of the problem involved in the faults localization in this process. We propose a method of fault detection applied to the diagnosis and to determine the gravity of a detected fault. We show the possibilities of application of the new approaches to the complex system control.
Modeling; Monitoring; Ultrasonic Linear Motor; Detection; Isolation; Bond Graph.
Abdelhakim Necir
.
Brahimi Brahim
.
pages 03-15.
Abd Essalam Badoud
.
pages 41-59.
Bensaoucha Saddam
.
Bessedik Sid Ahmed
.
Ameur Aissa
.
Seghiour Abdellatif
.
pages 106-116.
Kouadri Abdelmalek
.
Ikhlef Boualem
.
Bensmail Abderazak
.
pages 35-43.
Recioui Abdelmadjid
.
Tazibt Mohamed
.
Benhenni Hakim
.
pages 149-161.